Antique Allis Chalmers Tractor Parts

• To convert to 6 Volt system
• NEW, not Rebuilt

One Wire 63 Amp Alternator
(NEW not Rebuilt)

(10 square inch surface area, 6-1/4 inches housing diameter, 2-1/2 inches pulley diameter, 5/8 inch belt width) NOTE: Must rev engine to 800 - 850 RPM in order for unit to self excite. INSTALLATION: Run a wire from the alternator through the amp gauge to the positive side of the battery.

Mini 42 Amp 12 Volt Neg. Ground Alternator

Fits Allis Chalmers MODELS REQUIRING A SMALLER DIAMETER ALTERNATOR FOR CLEARANCE THAN OUR ABC418
Dimensions & Notes: 3 INTERNAL REGULATOR WIRE WITH WIRING INSTRUCTIONS --- 2 1/2" DIAMTER PULLY 3/8" BELT WIDTH 4 1/2" DIAMETER HOUSING --- REQUIRES A DIODE OR IDIOT LIGHT TO ISOLATE THE SYSTEM J400-52001

Alternator Pulley only

For ABC418 Alternator above. (.670" shaft diameter, 2-1/2 pulley O.D., 5/8" belt width)

Universal Alternator Mounting Kit

(Used when switching from a generator to an alternator) NOTE - Does not include the top adjusting bracket. J800-10001

Universal Top Adusting Bracket for Alternator Or Generator

Fits Allis Chalmers models, 7/8" WIDE, FARTHEST END OF SLOT TO CENTER OF MOUNTING HOLE IS 8 1/4", 3/8" MOUNT HOLE, 3 3/4" SLOT LENGTH