 |
 |
 |
 |
 |
Antique Case Tractor Parts
Generator Cut-Out Assembly
Fits Case Tractors: RC & V Series (1939-1943), Replaces Auto-Lite 9-4 & 9-5
(NOTE - Mounting tabs are parallel with cut out) J23101000
12 Volt (3 Terminal)
External Voltage Regulator (Saddle Mount)
Fits Case Tractors: 700, 730, 800, 830, 900, 930, 940 & 1030, Combines 800, 1000, 1010 & 1060, Replaces #1118991
- To convert 6 volt to 12 volt
- NEW, not Rebuilt
Mini 42 Amp Alternator
4-1/2" housing diameter, 2-1/2"pulley diameter,3/8"belt width (3 wire internal regulator w/wiring instructions. For tractors requiring a smaller diameter alternator for clearance)
Diode With 2 Spade Plug
Mini 42 AMP 12 volt negative ground alternator - use on a 3-wire alternator to prevent ignition feedback
One Wire 63 Amp Alternator
NEW not Rebuilt) (10 square inch surface area, 6-1/4 inches housing diameter, 2-1/2 inches pulley diameter, 5/8 inch belt width)
NOTE: Must rev engine to 800 - 850 RPM in order for unit to self excite. INSTALLATION: Run a wire from the alternator through the amp gauge to the positive side of the battery.
Alternator Pulley only
For ABC418 Alternator above. (.670" shaft diameter, 2-1/2 pulley O.D., 5/8" belt width)
Universal Alternator Mounting Kit
(Used when switching from a generator to an alternator) NOTE - Does not include the top adjusting bracket. J8001001
Top Adjusting Bracket
Fits: Case tractors (7/8"wide,1-1/2"offset,8-1/4" from farthest end of slot to center of mounting hole,3-3/4" slot length, 3/8" mounting hole
