 |
 |
 |
 |
 |
Antique Ford Tractor Parts
One Wire 63 Amp Alternator (NEW not Rebuilt)
(10 square inch surface area, 6-1/4 inches housing diameter, 2-1/2 inches pulley diameter, 5/8 inch belt width) NOTE: Must rev engine to 800 - 850 RPM in order for unit to self excite. INSTALLATION: Run a wire from the alternator through the amp gauge to the positive side of the battery.
Alternator Pulley only
For ABC418 Alternator above. (.670" shaft diameter, 2-1/2 pulley O.D., 5/8" belt width)
Alternator Conversion Kits
The follwing Alternator Conversion Kits will update
older 6-Volt tractors to 12-Volt charging system.
Alternator Conversion Kit with 12 volt Coil
For Ford early 9N, 2N; early 8N (1939-51) with front mounted distributor, to SN #263843 (Kit includes rebuilt unicharge alternator with pulley, internal self exciting regulator, 12 V coil, wiring harness, brackets, belt and instructions) Updates older 6V tractors to 12V charging system.
Alternator Conversion Kit
For Ford late 8N after SN #263844 with side mounted distributor (Kit includes rebuilt unicharge alternator with pulley, internal self exciting regulator, wiring harness, brackets, 12 V coil & instructions) Updates older 6V tractors to 12V charging system
Alternator Conversion Kit
For Ford NAA & Jubilee (Kit includes rebuilt unicharge alternator with pulley, internal self exciting regulator, wiring harness, brackets, 12 V coil, 12 V starter solenoid & instructions) Updates older 6V tractors to 12V charging system.
Alternator Conversion Kit
Fits Ford 501 - 4000 series (1955-64) with 4 Cylinder gas engine (Kit includes NEW not Rebuilt 63 Amp unicharge alternator with pulley, internal self-exciting regulator, electrical resistor, complete wiring harness, mounting brackets, alternator belt, installation instructions) 5564-10300ALT
Universal Alternator Mounting Kit
(Used when switching from a generator to an alternator)
NOTE - Does not include the top adjusting bracket. J800-10001
Universal Top Adusting Bracket for Alternator Or Generator
Fits Ford tractors (7/8" wide,
1 1/2" offset, 8 1/4" from farthest end of slot to center of mounting hole, 3 3/4 slot length, 3/8" mounting hole
