Antique International Tractor Parts

Generator Belt

Fits International / Farmall Tractor: Cub to SN #165152 with C60 Engine, Replaces #351321R1

Generator Belt

Fits International / Farmall Tractor: Cub to SN #165153 & Up & Cub Lo-Boy with C60 engine, Replaces #107671C1

Generator Belt

Fits International / Farmall Tractor: A, Super A up to SN #317191, Super A1 up to SN #317191, B, C & Super C up to SN #114645 (All w/ C-113 & C-123 engine), Replaces #49291D

Generator Belt

Fits International / Farmall Tractor: Super A SN #317192 & up, Super A1 SN #317192 & up, Super C SN #116646 & up, 100, 130, 200 & 230 (All w/ C-113 & C-123 engine), Also fits 400, W400 (Both w/ D264 diesel engine) for generator applications, 450 & W450 (Both w/ D281 diesel engine), Replaces #52318DA

Generator Belt

Fits International / Farmall Tractor: H, Super H, W4, Super W4, I4 & 3414 (All w/ C-152, C-164, BC-144 engine), 424, 2424 & 3414 (All w/ BD154 diesel engine), 600 & 350 (Both w/ D350 diesel engine), Replaces #48878D

Generator Belt

Fits International / Farmall Tractor: M, Super M, W6, Super W6, T6, 400, W400, 450 & W450, Replaces #49341D

6 Volt (4 Terminal) External Voltage Regulator (Saddle Mount)

Fits International / Farmall Tractor: Cub, Cub Lo-Boy, A, Super A, B, BN, C, H, I4, O4, W4, M, I6, O6, W6, I9, W9 & WR9, Replaces Delco Cut outs #1116766 & #1116809

6 Volt External (4 Terminal) Voltage Regulator (Flat Mount)

Fits International / Farmall Tractor: CUB, CUB LO-BOY, SUPER A, C, SUPER C, H, SUPER H, I4, O4, W4, M, SUPER M, SUPER MTA, I6, W6, I9, W9, WR9, MD, WD6, WD9, Replaces #354234R91, 121578C1, Delco Regulator # 1116807, 1116816, 1118291, 1118308, 1118780, 1118982, 1119575, D645, D657, JN231-12030
NOTE: REPLACES DELCO CUT-OUT #1116807 & 1116816 WHEN USED WITH ABC188 CONVERSION KIT --- FITS FOLLOWING DELCO GENERATORS: 1100025, 1100509, 1101404, 1100523, 1100529, 1100530, 1101857, 1101859, 1102102
BASE FLAT MOUNT --- 4-TERMINAL”

Voltage Regulator Conversion Kit

Fits International / Farmall Tractor: Note: (Used with 6 volts Regulators above when replacing Delco-Remy cutouts 1116766, 1116807, 1116809 & 1116816 or Cut-Outs 5839, 5851 & 5894 therefore modernizing the generator system

• To convert 6 Volt to 12 system
• New, not Rebuilt
  

One Wire 63 Amp Alternator (NEW not Rebuilt)

International / Farmall Tractor: 10 square inch surface area, 6-1/4 inches housing diameter, 2-1/2 inches pulley diameter, 5/8 inch belt width
NOTE: Must rev engine to 800 - 850 RPM in order for unit to self excite. INSTALLATION: Run a wire from the alternator through the amp gauge to the positive side of the battery.

Alternator Pulley with Nuts

For ABC418 Alternator above. (.670" shaft diameter, 2-1/2 pulley O.D., 5/8" belt width) 20101005

Mini 42 Amp 12 Volt Neg Ground Alternator

Fits International / Farmall Tractor: REQUIRING A SMALLER DIAMETER ALTERNATOR FOR CLEARANCE THAN OUR ABC418 J400-52001

Diode With 2 Spade Plug

Mini 42 AMP 12 volt negative ground alternator - use on a 3-wire alternator to prevent ignition feedback

Alternator Conversion Kit

Fits International / Farmall Tractor: M, MV, Super M, MTA gas, W6, W6TA, I6, O6 & OS6 (Updates older 6 Volt tractors to 12 Volt charging system ) (Kit includes rebuilt unicharge alternator with pulley, internal self exciting regulator, 12 Volt resistor, wiring harness, brackets, hardware & instructions)
Note: Mounts under hood without sheet metal modifications

Universal Alternator Mounting Kit

(Used when switching from a generator to an alternator) J800-10001
NOTE - Does not include the top adjusting bracket.

Top Adjusting Bracket

Fits: International / Farmall Tractor: (7/8" wide, 1-1/2" offset, 8-1/4" from farthest end of slot to center of mounting hole, 3-3/4" slot length,
3/8" mounting hole