Antique John Deere Tractor Parts

Antique John Deere Tractor Parts - Steering Shaft Repair End

Steering Shaft Repair End

Fits John Deere Tractor: M, MI, MT, 40, 420, 430, 435, 440, : 0.187" KEYWAY, 0.750" BORE, 2.025" LONG. MUST BE WELDED TO EXISTING SHAFT. REPAIRS ENDS WHEN THE KEYWAY STRIPS OUT.

Power Steering Hole Plug

Fits John Deere Tractor: 50, 60, 70, 80, 520, 530, 620, 630, 720, 730, 820, 830 & every Waterloo with Power Steering, Replaces #F1676R (Metal)

Char-Lynn Power Steering Parts

Slip Fit or Economy Coupler
(For Power Steering Conversion)

Fits John Deere Tractor: when equipped with Char Lynn Add-On Power Steering,

Torque Generator (Standard)

For when Pulling a wagon, etc..
(Torque Output at 1000 PSI = 7000 inch lbs., Rated Operating Pressure = 1000 PSI, Maximum Operating Speed at 3 GPM = 108 RPM, Recommended Fluid Input = 2.5 to 3 GPM)

Torque Generator (Heavy Duty)

For when Front Loader is used
(Torque Output at 1000 PSI = 1100 inch lbs., Rated Operating Pressure = 1000 PSI, Maximum Operating Speed at 3 GPM = 65 RPM, Recommended Fluid Input = 3 to 4 GPM)

Port Block

Needed only if either of the above Torque Generators are purchased.

Power Steering Priority Flow Control Valve

Fits John Deere Tractor: A, B, G, AN, AW, ANH, AWH, BN, BW, BNH, BWH, GM, GW, GN, GH, 50, 60, 70, 520, 620, 720 -- ALL WITH LIVE HYDRAULICS (3/4" INLET & RETURN, 1/2" PRESSURE PORT)
NOTE: ELIMINATES BELT DRIVEN PUMP, PULLEYS & BRACKETS. ENABLES YOU TO USE YOUR LIVE HYDRAULIC PUMP TO OPERATE THE POWER STEERING. --- MUST BE USED W/ LIVE HYD. --- 3/4" INLET & RETURN --- 1/2" PRESSURE PORT -- PRE SET AT 1500 PSI, ADJUST TO YOUR APPLICATION

Antique John Deere Tractor Parts - Wide Front Pivot Bolster

JD M Wide Front Pivot Bolster

Fits John Deere Tractor: M using (2) JD #M4158T Bushings (Bushings not supplied), Will replace # M1392T, Direct Replacement for MT, 40T, 420T & 430T, Replaces #M4156T