Antique Massey Harris / Ferguson Tractor Parts

Antique Massey Harris - Ferguson Tractor Parts - Generator Cut-Out Assembly

Cover Band (1-5/8" Wide)

Fits Delco 2 & 3 Brush Generators, 4-1/2" dia - Cover band encircles field case and "clips" to itself, "Rolling-Up" the Opposite End from the clip shortens the band and increases clamp tension when "clipped", Delco #816340

Mechanical or Electronic Generator Cut-Out Assembly

Fits Massey Harris Tractors: built 1951 & earlier with cut-out & 6-Volt Autolite System, Replaces #1500199M91 (NOTE - Mounting tabs are parallel with cut out)

Voltage Regulators

6 Volt External Voltage Regulator
(4 Terminal) (Flat Mount)

Fits Massey Ferguson Tractors: TE20, TO20, TO30 & TO35, Replaces 180142M92 & Delco Regulator 1116807, 1116816, 1118291, 1118308, 1118780, 1118982, 1119575, D645, D657, JN231-12030

Voltage Regulator Conversion Kit

For Massey Ferguson Tractors: using above 6 Volt Voltage Regulator when replacing Delco Remy cut-outs #1116766, #1116807, #1116809 & #1116816 (Conversion Kit Insulation "F" terminal on regulator to "F" terminal on generator)

12 Volt Voltage Regulator

Fits Massey Harris Tractor: 50, Massey Ferguson Tractors: TO35, F40, MF35, MF65, MF85, MF88, MF Super 90, MF135, MF150, MF165, MF175, MF180, MF202, MF204, MF203, MF205, MF2135 & MF3165, COMBINES - SP300, SP410 & SP510 Replaces 182548M92 - 231-12030

Alternators

• To convert 6 Volt to 12 Volt system
• New, not Rebuilt

One Wire 63 Amp Alternator
(NEW not Rebuilt)

(10 square inch surface area, 6-1/4 inches housing diameter, 2-1/2 inches pulley diameter, 5/8 inch belt width) NOTE: Must rev engine to 800 - 850 RPM in order for unit to self excite. INSTALLATION: Run a wire from the alternator through the amp gauge to the positive side of the battery.

Alternator Pulley only

For ABC418 Alternator above. (.670" shaft diameter, 2-1/2 pulley O.D., 5/8" belt width)

Diode With 2 Spade Plugs

Fits Massey Ferguson Tractors: Requiring Smaller Diameter Alternator For Clearance Than Our ABC418 4-1/2" Dia housing --- 2-1/2" Dia Pulley --- .590" OD shaft for drive pulley --- 3/8" Belt width --- 3-Wire internal regulator with wiring instructions --- For tractors requiring a smaller Dia alternator for clearance --- New, not rebuilt --- To convert 6-V to 12-V system --- For negative ground systems only

Alternator Mounting Kit

Universal Alternator Mounting Kit

Fits Massey Harris & Massey Ferguson Tractors:
(Used when switching from a generator to an alternator) NOTE - Does not include the top adjusting bracket. J8001001

Top Adjusting Bracket

Fits Massey Ferguson Tractors: TE20, TEA20, FE35, TO35 & MF35 Replaces #180563M1 (seat), #180572M1 (spring) & #180528M91 (bearing assy