Antique Minneapolis Moline / B.F. Avery
Tractor Parts

Slip Fit Coupler
(For Power Steering Conversion)

Fits Minneapolis Moline models when equipped with Char Lynn Add-On Power Steering, Oliver models when equipped with Char Lynn Add-On Power Steering

Power Steering Priority Flow Control

Fits MM: MM MODELS WITH LIVE HYDRAULICS Dimensions & Notes: ELIMINATES BELT DRIVEN PUMP, PULLEYS & BRACKETS. ENABLES YOU TO USE YOUR LIVE HYDRAULIC PUMP TO OPERATE THE POWER STEERING. --- MUST BE USED W/ LIVE HYD. --- 3/4" INLET & RETURN --- 1/2" PRESSURE PORT -- PRE SET AT 1500 PSI, ADJUST TO YOUR APPLICATION

Torque Generator
(Standard)

For when pulling a wagon, etc... (Torque Output at 1000 PSI = 7000 inch lbs., Rated Operating Pressure = 1000 PSI, Maximum Operating Speed at 3 GPM = 108 RPM, Recommended Fluid Input = 2.5 to 3 GPM)

Torque Generator
(Heavy Duty)

For when a front loader is used (Torque Output at 1000 PSI = 1100 inch lbs., Rated Operating Pressure = 1000 PSI, Maximum Operating Speed at 3 GPM = 65 RPM, Recommended Fluid Input = 3 to 4 GPM)

Port Block

Needed only if above Torque Generators are purchased

Economy Char-Lynn Steering Coupler

Fits MM: MM MODELS Dimensions & Notes: USE ONLY IF YOU HAVE A UNIVERSAL JOINT AT ONE END OF EXISTING STEERING SHAFT

Tie Rod Boot

Fits Minneapolis Moline models, (1-13/16 inch (Base) X 7/8 inch (Height) X 5/8 inch (Hole I.D.)

Tie Rod Boot

Fits Minneapolis Moline models, (1-9/16 inch Base X 1 inch Height X 1/2 inch Hole I.D.)

Tie Rod Boot

Fits Minneapolis Moline models, (1-15/16 inch Base X 3/4 inch Height X 3/4 inch Hole I.D.)

Dust Cover (Seal)
For Steering Drag Link Front Ball Joint

Fits Minneapolis Moline models

Dust Cover (Seal)
For Steering Drag Link Front Ball Joint

Fits Minneapolis Moline models