Antique Minneapolis Moline / B.F. Avery
Tractor Parts

Antique Minneapolis Moline – Avery Tractor Parts -
Generator Cut-Out Assembly

One Wire 63 Amp Alternator
(NEW not Rebuilt)

(10 square inch surface area, 6-1/4 inches housing diameter, 2-1/2 inches pulley diameter, 5/8 inch belt width) NOTE: Must rev engine to 800 - 850 RPM in order for unit to self excite. INSTALLATION: Run a wire from the alternator through the amp gauge to the positive side of the battery

Alternator Pulley only

For ABC418 Alternator above. (.670" shaft diameter, 2-1/2 pulley O.D., 5/8" belt width)

Mini 42 Amp Alternator W/Pulley & Diode

4-1/2" House Diameter, 2-1/2" Pulley Diameter, 3/8" Belt Width --- 3 Wire Internal Regulator W/ Wiring Instructions. For Tractors Requiring A Smaller Diameter Alternator For Clearance. --- New Not Rebuilt --- To Convert 6 Volt To 12 Volt System --- For Negative Ground Systems Only

Diode With 2 Spade Plug

Mini 42 AMP 12 volt negative ground alternator - use on a 3-wire alternator to prevent ignition feedback

Universal Alternator Mounting Kit

(Used when switching from a generator to an alternator) NOTE - Does not include the top adjusting bracket. J800-10001

Universal Top Adjusting Bracket For Alternator Or Generator

Fits Minneapolis Moline Tractors: 7/8" WIDE, FARTHEST END OF SLOT TO CENTER OF MOUNTING HOLE IS 8 1/4", 3/8" MOUNT HOLE, 3 3/4" SLOT LENGTH

Antique Minneapolis Moline – Avery Tractor Parts - Voltage Regulators

Cover Band (1-5/8" Wide)

Fits Delco 2 & 3 Brush Generators, 4-1/2" dia - Cover band encircles field case and "clips" to itself, "Rolling-Up" the Opposite End from the clip shortens the band and increases clamp tension when "clipped", Delco #816340

6 Volt (4 Terminal) External Voltage Regulator
(Saddle Mount)

Fits Minneapolis Moline Tractors: 335, R, Z, U series, GTA & GTB using Generator #1100505, Replaces MM #10A20736

12 Volt (4 Terminal) External Voltage Regulator
(Saddle Mount)

Fits Minneapolis Moline Tractors: GB, GTB, BVI, U, Jet Star, Jet Star 3, Jet Star 4, 5 Star, M5, M602, G900, G950, G1000, G1050, G1350, M504, M604, M670, U302, ZA, ZB, 335 & 445 using Generators #1100314, #1100417, #1147579, #1101783, #1101954 & #1100334

Mechanical and Electronic Generator Cut-Out Assembly

Fits Avery Tractor:
(NOTE - Mounting tabs are parallel with cut out)

Generator Belt

Fits Minneapolis Moline Tractors: Z SERIES, R SERIES Dimensions & Notes: 17/32" X 34-1/8" --- ALL WITH DELCO GENERATOR Replacement: MM: KE1112