Antique White / Oliver Tractor Parts

Generator Cut Out Assembly

Fits Oliver: 60, 70 Dimensions & Notes: 15 AMP --- FOR AUTOLITE DISTRIBUTOR --- MOUNTING TABS ARE PARALLEL WITH CUT OUT Replacement: 1867781, C4012(9-1), 9-4, 9-5, CB4014, 1116809DR, R40061, 1500199M91

6 Volt (4 Terminal) External Voltage Regulator
(Saddle Mount)

Fits Oliver Super 44, Super 55, 66, 77, Super 77, 80, 88, Super 88, 99 & Super 99

12 Volt (4 Terminal) External Voltage Regulator
(Saddle Mount)

Fits Oliver Super 55, 66, Super 66, 77, Super 77, 88, Super 88, 99, Super 99, 550, 660, 770 & 880 using generators #1100314 & #1100322, Replaces Delco #K7786D & #1118791

• To Convert 6 Volt to 12 Volt system
• New, not Rebuilt

One Wire 63 Amp Alternator
(NEW not Rebuilt)

(10 square inch surface area, 6-1/4 inches housing diameter, 2-1/2 inches pulley diameter, 5/8 inch belt width) NOTE: Must rev engine to 800 - 850 RPM in order for unit to self excite. INSTALLATION: Run a wire from the alternator through the amp gauge to the positive side of the battery.

Alternator Pulley only

For ABC418 Alternator above. (.670" shaft diameter, 2-1/2 pulley O.D., 5/8" belt width)

Mini 42 Amp Alternator

Fits Oliver: OLIVER MODELS Dimensions & Notes: 4-1/2" HOUSING DIAMETER, 2-1/2" PULLEY DIAMETER, 3/8" BELT WIDTH --- 3 WIRE INTERNAL REGULATOR W/ WIRING INSTRUCTIONS. FOR TRACTORS REQUIRING A SMALLER DIAMETER ALTERNATOR FOR CLEARANCE. --- NEW NOT REBUILT --- TO CONVERT 6 VOLT TO 12 VOLT SYSTEM --- FOR NEGATIVE GROUND SYSTEMS ONLY

Diode With 2 Spade Plug

Mini 42 AMP 12 volt negative ground alternator - use on a 3-wire alternator to prevent ignition feedback

Universal Alternator Mounting Kit

(Used when switching from a generator to an alternator) NOTE - Does not include the top adjusting bracket. #J8001001

Top Adjusting Bracket

Fits Oliver: OLIVER MODELS Dimensions & Notes: 7/8" WIDE, FARTHEST END OF SLOT TO CENTER OF MOUNTING HOLE IS 8 1/4", 3/8" MOUNT HOLE, 3 3/4" SLOT LENGTH